We picked ribbon sapele as the veneer on the outside, which looks like this:
Turns out, it wasn't that much more expensive to have them cut out the profile via CNC after doing the custom veneer layup, so this is a preview of the side:
We used that profile and a pattern bit to cut a pattern piece on which we'll do most of the "dirty work":Then we started framing the walls. You do this by cutting pieces of 1x4" to follow the profile of the pattern. Then you add vertical 1x2 "beams" to support the frame, and frame out any areas which will need support. After the verticals are in, you flush trim the outside of the to the profile of the trailer.
In addition to joining via Kreg, we also splined the edges. Why? It prevents twisting when we cut off the roof. You'll see what I mean later.
We made splines ourself out of a 1/4" piece of birch and a hole cutter bit on the drill press. We then cut those in half and made the spline slots with the router. The wood is only 5/8" thick, so normal biscuit joinery would be too big.
Here's what they look like glued in place:
We then flush trimmed them mostly smooth, so the splines wouldn't get in the way of any vertical members:
I don't have photos yet, but we're in the process of doing the supports of the wall framing!







No comments:
Post a Comment